طبق بالا اف جی - پرادو OLDMAN EMU

Forged Ball Joint Housing Forged Eyelets Heavy Duty greasable Ball Joint OME Ball joint protective cap GIIRO bushings, free pivoting, grease free and maintenance free Increased camber and caster for 2 inch (50mm) lift Mount provision for OE ABS wires ARB's Intergrit powder coat finish Boxed in pairs with foam inserts OME Branded outer sleeve Tested and passed to meet VSB14 requirements Engineered for use with OME GVM upgrades Designed and manufactured in Australia Fitting instructions are included After fitment, a wheel alignment is required If the vehicle is fitted with aftermarket tires or wheels, fender clearance should be checked Additional caster may be required if tires or wheels do not clear The Upper Control Arm will provide an increase between +2.5 and +3.5 degrees of caster and up to 1.5 degrees of negative camber increase (figures based off an approximate 50mm or 2 inch lift) Installation may require the use of specialized tools and/or techniques It is recommended that this product is only installed by trained personnel During installation, it is the duty of the installer to check correct operation and clearances of all components Work safely at all times These fitting instructions should be read in conjunction with the vehicle workshop manual Torque Upper Control Arm and Ball joint nut to OE specification After greasing the ball joint, install the protective cap with the screw provided